Replacing/Installing The Side Brushes - Tennant VLX Manual De Instrucciones

switch to the OFF position.
• remove the back panel from the
•
seat by turning locking restraining
•
air (maximum pressure 6 bars).
•
• close the back panel.
REPLACING/INSTALLING
THE SIDE BRUSHES
To facilitate transport, the side brush (or
position. To install the side brush in the correct
position, proceed as follows:
• move the side brush control lever to the
up position.
• unscrew the screw on the side brush
motor shaft.
• remove the key protector.
•
the shaft.
•
22).
To replace worn side brushes, carry out the
operations listed above.
EN 16