To Remove The Cutting Blade; To Set The Cut Depth Indicator - Husqvarna FS 500 E Manual De Usuario

Idiomas disponibles

4. Loosen the front nut and tilt the blade guard to the

servicing position.

5. Remove the blade screw (A).

6. Remove the blade flange (B).

7. Examine the blade screw (A), the blade flange (B)

and the inner flange (C) for damages. Replace worn

or damaged parts.

8. Clean the contact surfaces of the cutting blade and

the flanges.

9. Install the cutting blade on the inner flange (C).

10. Make sure that the cutting blade rotates in the

direction of the arrows shown on the cutting blade.

CAUTION: Risk of damage to the cutting

blade if it is installed opposite the

direction of rotation.

11. Install the blade flange (B) and the blade shaft bolt

(A). Make sure that the locking pin (D) on the inner

flange, goes through the cutting blade and into the

blade flange (B).

12. Hold the cutting blade tightly, while you tighten the

screw (A) with the supplied wrench.

13. Turn the cutting depth wheel clockwise to lower the

cutting blade.

14. Tighten the screw (A) fully with the supplied wrench.

The resistance between the cutting blade and the

ground keeps the cutting blade in position.

15. Install the blade guard and attach the water hose.

16. Start the product and listen for unusual sounds. If

there are unusual sounds, remove the cutting blade.

a) Examine the cutting blade for damages.

b) Install the cutting blade again. Replace the

cutting blade if it is damaged.