Sat-Receiver Test - Promax RP-050 Manual De Instrucciones

3.2.2 SAT-receiver test

Connect jack [1] RECEIVER to the RP-050 with the IF - input jack
1.-
(SAT-antenna input) of the SAT-receiver to be tested.
2.- Connect SAT-receiver and television set (SCART-socket or RF-
connector).
3.- Switch on SAT-receiver and television set, in case of connection via
SCART-socket, switch television set to the AV-channel.
4.- In case of connection via RF-connector, tune SAT-receiver to
television set (with the help of the internal receiver pattern).
5.- Switch on RP-050, slide attenuation selector switch [2] to LOW
mode or HIGH mode.
6.- Tune on the SAT-receiver one pilot IF frequency (1050 MHz, 1575
MHz or 2100 MHz) on L band. On the television set, there must be
visible a picture with two black and one white bar.
If, in addition, the SAT-receiver is tuned in the audio stage to 7.02
MHz (± 0.2 MHz), a tone of approximately 1 kHz will be audible in the TV
set.
Consequently, the video and audio stage of the SAT-receiver can
be checked.
09/03
Figure 3.- SAT-receiver test
- 9 - RP-050