Operating Modes Of The Hmir - WEG MW500 Serie Manual Del Usuario

4.3 OPERATING MODES OF THE HMIR

The HMIR must be configured via hardware on S10 DIP-switch before the operation. The S10
DIP-switch is shown in
recognizing the HMIR the inverter can be adjusted as shown in
ID S10.1 S10.2
0 OFF
1 OFF
2 OFF
3 OFF
4 OFF
5 OFF
6 OFF
7 OFF
8 ON
9 ON
10 ON
11 ON
12 ON
13 ON
14 ON
15 ON
The monitoring mode allows the user to view up to three variables on the main display, secondary
display and bar graph. Such fields of the display are defined in
The setting mode is composed of three levels: Level 1 allows the user to select the Menu items in
order to browse the parameters. Level 2 allows browsing the parameters of the group selected
by level 1. Level 3 allows the modification of the parameter selected in Level 2. At the end of
this level, the modified value is saved or not if the key ENTER or ESC is pressed, respectively.
Figure 4.3 on page 22 illustrates the basic browsing of the operating modes of the HMIR.
Figure A.2 on page 124
Table 4.1: S10 DIP-switches configuration
S10.3 S10.4
OFF OFF OFF
OFF OFF ON
OFF ON OFF
OFF ON ON
ON OFF OFF
ON OFF ON
ON ON OFF
ON ON ON
OFF OFF OFF
OFF OFF ON
OFF ON OFF
OFF ON ON
ON OFF OFF
ON OFF ON
ON ON OFF
ON ON ON
Keypad (HMIR) and Basic Programming
of APPENDIX A - PARTS on page
Table 4.1 on page
Power-Up Function
None
Load 50 Hz factory parameter table standard
Load 60 Hz factory parameter table standard
None
None
None
None
None
Force HMI serial protocol
Force Modbus RTU serial protocol
None
None
None
None
None
None
Figure 4.2 on page
123. For
21.
20.
MW500 | 21