Maintenance And Care - Flex ALR 411 M Instrucciones De Funcionamiento

Rotational laser
Vertical application
n Place the power tool on a surface which
is as level as possible.
n Align the machine with the aid of the
vertical spirit level (13) by rotating the
foot screw (11). The bubble in the spirit
level must be situated exactly in the
middle between the marks.
n Switch on the power tool.
The beam begins to rotate.
The LEDs (6, 13) light up permanently.
On completion of work:
n Switch off the appliance.
Checking precision
Caution!
The power tool may be adjusted by
authorised technicians only.
n Place the power tool 10 m from a wall.
n Switch on the power tool.
Operating mode: rotating laser beam.
n Mark the position of the laser beam (X)
on the wall.
n Rotate the power tool by 180°
(tripod recommended).
n Mark the position of the laser beam (Y)
on the wall.
The centre between the two marks (X) and
(Y) is the correct value from which the two
marks must not deviate by more than 3/10 m.
n To check the precision, rotate the power
tool by 90° and repeat the entire
process.

Maintenance and care

Cleaning
If the power tool is damp after use, wipe the
power tool and accessories with a dry, soft
cloth.
Do not use solvents or abrasive cleaning
agents to remove dirt. Use a clean cloth
moistened with water and a mild detergent.
Remove dust from the laser beam discharge
window (6, 7) with a soft paint brush, etc.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Accessories
Spare-part/Accessory
Laser visibility glasses (improved
visibility of the laser beam)
Wall and ceiling holder (ALR)
Clamping column
Elevator tripod, medium-sized
(0.65–2.00 m)
Elevator tripod, large
(0.90–2.85 m)
Order
no.
312.134
312.088
312.096
312.118
312.126
17