Zanussi ZWT 71401 WA Manual De Instrucciones página 8

if the selected programme/option it requires (see more de-
tails in «Detergent dispenser drawer»).
If required, pour fabric softener into the compartment
marked (the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by turning the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme. The washing machine will propose a temperature
and automatically select the maximum spin value provi-
ded for the programme you have chosen. You can change
these values by operating the corresponding buttons. The
green pilot light of the button 8 starts to flash.
The selector dial can be turned either clockwise or coun-
terclockwise. Turn to position
Switching the machine off.
At the end of the programme the selector dial must be
turned to position , to switch the machine off.
Caution! If you turn the programme selector dial to
another programme when the machine is working,
the red pilot light of button 8 will blink 3 times and the
message Err is displayed to indicate a wrong selection.
The machine will not perform the new selected
programme.
8
to reset programme/
Reduce the spin speed by pressing button 2
By selecting a programme, the appliance proposes auto-
matically the maximum spin speed provided for that pro-
gramme.
Press button 2 repeatedly to change the spin speed, if you
want your laundry to be spun at a different speed. The rel-
evant light illuminates.
Select the available options by pressing buttons 3, 4
and 6
Depending on the programme, different functions can be
combined. These must be selected after choosing the de-
sired programme and before pressing button 8.
When these buttons are pressed, the corresponding icons
appear on the display. When they are pressed again, the
icons disappear. If an incorrect option is selected, the in-
tegrated red pilot light of the button 8 flashes for 3 times
and the Err message appears on the display for a few sec-
onds.
For the compatibility among the washing pro-
grammes and the options see chapter «Washing
Programmes».
Select the Delay Start by pressing button 10
Before you start the programme, if you wish to delay the
start, press the button 10 repeatedly, to select the desired
delay.
The selected delay time value (up to 20 hours) will appear
on the display a few seconds, then the duration of the pro-
gramme will appear again.
You must select this option after you have set the pro-
gramme and before you press button 8.
You can cancel or modify the delay time at any moment,
before you press button 8.
Selecting the delayed start:
1. Select the programme and the required options.
2. Select the delay start by pressing the button 10.
3. Press button 8:
– the machine starts its hourly countdown.
– The programme will start after the selected delay
has expired.
Cancelling the delayed start after having pressed button 8:
1. Set the washing machine to PAUSE by pressing but-
ton 8.
2.
Press button 10 once until the symbol
played
3. Press button 8 again to start the programme.
' is dis-
www.zanussi.com