Mounting The Frame; Adjusting The Seat Height - Vermeiren EZ1 Manual De Instrucciones

3.3

Mounting the frame

L L L L
WARNING:
Risk of clamping – Check that no cables become squeezed or
pinched.
L L L L
WARNING:
Risk of injury – Make sure that the safety pin Ⓐ Ⓐ Ⓐ Ⓐ is firmly closed.
Mounting the frame after taking the wheelchair out of the original packaging:
1. Position the backrest in the 90° position.
2. Move the safety pin Ⓐ in the corresponding holes. One to fix the gas spring Ⓑ, which
is located below the rear of the seat frame.
3.4

Adjusting the seat height

L L L L
WARNING:
Risk of injury – Make sure that all screws are tightened securely.
Check that the screws are not damaged.
L L L L
WARNING:
Risk of injury – Self-locking nuts may only be used once.
L L L L
WARNING:
Risk of injury – Avoid getting your fingers caught during the
assembly process.
L L L L
WARNING:
Risk of tipping over – Make sure when adjusting the seat height, the
seat frame will not be positioned with an inclination.
A
Axle block drive wheels
1. Unscrew the two screws that mounted the axle block of the rear wheels to the
frame.
2. Move the axle block to the desired height (steps 15 mm).
3. Retighten the two screws.
4. Adjust the brakes.
Page 15
2012-12
A = Safety pin
B = Gas spring
EZ1