Adjusting The Seat Depth - Vermeiren EZ1 Manual De Instrucciones

Steering wheel adapter
B
1. Unscrew the two screws from the steering wheel adapter.
2. Place the steering wheel adapter in the desired position (2 positions: steps 34
mm).
3. Tighten the screws properly.
Front wheel fork
C
1. Unscrew the screws of the front wheel axles from the front fork.
2. Place the steering wheel in the desired position of the steering fork (steps 12,5
mm)
3. Tighten the screws properly.
3.5

Adjusting the seat depth

L L L L
WARNING:
Risk of injury – Make sure that all screws are tightened securely.
Check that the screws are not damaged.
L L L L
WARNING:
Risk of injury – Self-locking nuts may only be used once.
L L L L
WARNING:
Risk of injury – Avoid getting your fingers caught during the
assembly process.
When the seat depth is adjusted in the limitations of the back frame and the gas pressure
spring for the backrest adjustment is used, there can be created a gap between the backrest
and seat cushions.
1. Loosen the screws on both sides, where the frame of the backrest is connected
A
to the seat frame.
2. Pull the frame of the backrest in de desired position (4 positions: steps 20 mm)
3. Retighten the screws on both sides.
4. Adjust the brakes.
B
1. Loosen the screw where the footrest is secured in the seat frame.
2. Move the tube of the footrests in the desired position (stepless).
3. Retighten the screws properly.
1. Pull the lever for moving the seat frame upwards. These lever is located on the
C
frontside just under the seat.
2. Move the seat to the desired position (stepless).
3. Release the lever again. The seat is locked in place.
C
Page 16
EZ1
2012-12