Technical Specifications; Instructions For Use - Grillo MD22 N Manual De Instrucciones

MD22 N/ Translation of the original instructions

TECHNICAL SPECIFICATIONS

ENGINE: - B&S INTEK 7220 PROFESSIONAL SERIES OHV 656 cm³ 18HP twin-cylinder petrol.
STARTER: electric with 12V battery.
FUEL TANK: 7 Litres – RESERVE: 1 litre.
GEARBOX: hydrostatic transmission fitted with a differential.
DIFFERENTIAL: on the rear wheels via pedal control.
STEERING RADIUS: 48 cm.
CLUTCH: electromagnetic with P.T.O and blade brake.
SPEED: continuously variable from 0 to 10,5 km/h, reverse speed from 0 to 6 km/h.
WHEELS: front TURF TYRES 15×6.00-6; rear TURF TYRES: 20x 10.00-8.
BRAKES: pedal operated front wheel brakes – emergency and parking brake on the rear wheels via
lever control.
SEAT: high-comfort, sprung and adjustable seat, equipped with armrests and roll-bar.
CUTTER DECK: rear discharge or mulching via a "Quick Shift" lever.
CUTTING SYSTEM: 3 rotating blades.
CUTTING WIDTH: 110 cm (±43'').
CUTTING HEIGHT: continuously adjustable from 25 to 110 mm (±0.6'' to 4'').
APPROX HOURLY CUTTING CAPACITY: 8.500 m 2 /h (± 2 acres per hour)
STANDARD FEATURE: tow hitch.
ATTACHMENTS: front and rear TURF TYPE TYRES.
WEIGHT: 315 kg (±694 lb)
SIZE: Length: 1940 mm – Width: 1110 mm – Height: 980 mm

INSTRUCTIONS FOR USE

1) Check that the machine has not been damaged during transport.
2) Check the engine oil level (fig. 4) and the hydrostatic transmission oil level (fig. 10).
3) Check the tyre pressure: 1 BAR front wheels 15X6.00-6 – 1 BAR rear wheels 20X10.00-8
4) Check the battery voltage (fig. 21), it must be at least 12 Volts. Charge if necessary.
IMPORTANT: During assembly take care not to reverse the polarity of the battery.
5) Fix the steering wheel taking care to insert the key properly and to tighten the bolt correctly
(tightening torque 2 KgF.m [20 Nm]).
6) Fit the roll-bar.
RUNNING IN – CAUTION!!
Change both the engine oil and filter after the first 20 working hours. Check that there are no oil leaks
or loose screws, especially those fixing the blades and the steering.
BEFORE STARTING THE ENGINE
Before starting the engine, always check that:
– the forward lever is in the idle position (fig. 3, n. 2);
– the engine oil level is correct (fig. 4);
– the engine cooling intake grids are clean (fig. 4);
– the air filter is clean (fig. 7.
– the mower deck is clean;
– the hydraulic transmission fins are clean (fig. 6);
9