DeWalt DW714 Manual De Instrucciones página 54

ENGlIsH
Fig. M
9
Checking and Adjusting the Blade to
the Table (Fig. N–S)
1. Loosen the bevel clamp knob
Fig. N
2. Press the miter arm to the right to ensure it is fully
vertical with the angle position stop
the vertical position adjustment stop
the bevel clamp knob.
Fig. O
3. Pull down the head until the blade just enters the saw
kerf .
19
4. Place a set square on the table and up against the
46
blade 41 (Fig. P).

WARNING: Do not touch the tips of the blade teeth
with the square.
52
46
16 .
16
26 located against
28 and tighten
26
28
Fig. P
22
If adjustment is required, proceed as follows:
5. Loosen the lock nut 49
sure the stop screw is firmly in contact with the
28
angle position stop , turn the vertical position
26
adjustment stop screw 28
90º to the table as measured with the square.
Fig. Q
6. Firmly tighten the lock nut
screw 28 stationary.
Fig. R
7. If the bevel pointer does not indicate zero on the
50
bevel scale 17 , loosen the screw
pointer and move the pointer as necessary.
19
46
a few turns, and while making
in or out until the blade is at
26
28
49
while holding the stop
49
26
28
49
51 that secures the
41