Bosch DHD Instrucciones De Instalación página 7

Step2:Prepare C ountertop C utout
Refer tothe cooktop installation instructions
fordimensions ofcook,top, countertop
cutout, and cabinet requirements prior t o
making any cutouts. Cook,top depth a nd
countertop back,-splash depth c an vary
greatly from one toanother. These variati-
ons may cause the fitofthe downdrafl and
cook,top tobetight. Acountertop (front
edge) with araised l ipand/or awide back,s-
plash ( back edge) may n otallow enough ftat
countertop fora proper installation.
[] Check` that t he cook,top isfarenough
forward that t he downdraft will f itbehind
it.Verify all d imensions prior tocutting
thecountertops.
Use thephysical products toconfirm
cutouts w henever possible.
For a ll i nstallations verify that a ll c utouts will
clear the inside ofthe front c ountertop sup-
port r ail, a nd that t he cook, topand vent will
becentered left t oright w ithin t he cutout.
Also, make c ertain that t he front
and rear c utouts are straight and parallel to
the front edge o fcountertop and the rear
back,splash and/or wall. Assure that t he
side cutouts are square tothe front and rear
cutouts.
All i llustrations and dimensions are based
onstandard 24" deep by36" high A merican
style b ase c abinets with 25" countertops.
When i nstalling laminated orsolid s urface
countertops such asSurell
TM
and Corian _,
be sure to follow the countertop manufac-
turer's instructions regarding minimum
comer radii, reinforcement of corners, etc.
Note: Check` boxes as tasks are completed.
INSTALLATION WITH COOKTOPS
Fig. 7
Notes
Dimension "SB" is the minimum distance from the leading edge of the counter to the lea-
ding edge of the cutout.
Dimension "BT" is the thickness of back,splashthat provides 1/4" clearance between vent
and back,splash. Any back,splash with a curved radius where it meets the counter will requi-
re additional clearance. Thicker back,splashes may be used by increasing the counter and
cabinet depths.
Set the cook,top into the countertop opening so that the back edge of the cook,top overlaps
the leading edge of the downdraft.
For overhead cabinet and cooktop side
clearances consult cooktop Installation
Instructions.