Publicidad
Idiomas disponibles
Idiomas disponibles
Step7:Mount I ntegral Blower o r
Outlet D uctTransition f or Remote o r
Iniine Blower
Integral Blower (see Figures 9and 11for
further detail):
[] A.Attach blower infront o fround e x-
haust outbt w ith 4-6(depending
oncon-
figuration)
#8sheetmetal
screws.
[] B.Feed c ord from blower through strain
relief.
[] C.Secure strain r elbf w ith screws.
[] D.Attach strain r elbf t odowndraft
near
junction box.
[] E. C onnect cord todowndraft
at6pin
connector.
[] RConnect blower toductwork.
[] G.Place the cooktop incountertop
ope-
ning w ith the rear edge o fcooktop over-
lapping the front e dge o fthe vent. Make
sure rear edge o fcooktop does n ot b ind
against front ofsnorkek Follow t he ma-
nufacturer's
installation
Instructions
for
installing
gasket strips, protective
heat
tape (ifrequired),
securing the cooktop
tothe countertop
and making the cook-
topebctrical and/or gas connections.
Note: Check b oxes astasks a re completed.
6Pin
Connector
/
Internal Blower
Strain Relief
Fig. 9 -Internal
Blower
Publicidad
