Adjusting The Mowing Height - Makita DLM431 Manual De Instrucciones

2. Press the switch button and hold it.
3. Grab the upper handle and pull the switch lever.
1
► 1. Switch button 2. Switch lever
4. Release the switch button as soon as the motor
starts running. The mower will continue to run until you
release the switch lever.
5.
Release the switch lever to stop the motor.

Adjusting the mowing height

WARNING:
Never put your hand or leg under
the mower body when adjusting the mowing
height.
WARNING:
Always make sure that the lever
fits in the groove properly before operation.
The mowing height can be adjusted in the range of
between 20 mm (13/16") - 75 mm (2-15/16").
1. Remove the lock key.
2. Pull the mowing height adjusting lever to the
outward of the mower body and move it to your desired
mowing height.
► 1. Mowing height adjusting lever
NOTE: The mowing height figures should be used
just as a guideline. Depending on the conditions of
the lawn or the ground, the actual lawn height may
become slightly different from the set height.
NOTE: Try a test mowing of grass in a less conspicu-
ous place to get your desired height.
ASSEMBLY
WARNING:
2
and battery cartridge are removed before carrying
out any work on the mower. Failure to remove the
lock key and the battery cartridge may result in seri-
ous personal injury from accidental start-up.
WARNING:
completely assembled. Operation of the tools in a
partially assembled state may result in serious per-
sonal injury from accidental start-up.
Installing the battery cover
WARNING:
tery cartridge before installing the battery cover.
Failure to do so may cause a serious injury.
Install the battery cover completely before the opera-
tion. The battery cover protects the mower and battery
cartridge from mud, dirt, and water.
1. Place the battery cover with the protrusions on the
mower aligned to the holes on the battery cover.
► 1. Protrusion 2. Hole 3. Battery cover
1
2. Place your hands in the middle of the battery
cover and push it.
3. Before the first operation, check that the pivot
point of the battery cover is attached properly. If the
battery cover is installed correctly, it will not open until
the battery cover locking lever is pulled.
7 ENGLISH
Always be sure that the lock key
Never start the mower unless it is
Do not insert the lock key and bat-
2
1
3