Dive Historic Memory ( ) - Cressi Archimede II Manual De Instrucciones

on the UFDS display. The second display mode giving the
dive's number followed by (...-2) will be replaced by the dive's
number followed by "...-3", that is, the third logbook display
mode, which displays the following information (picture 29):
1 Mixture used for the dive in
( ) will appear, if a Nitrox mixture dive, the display FO2
and the icon relating to the given mixture (MIX1 or MIX2),
automatically alternating both values, starting from the pri-
mary one (pictures 30 a – b)
NOTE: Should the second Nitrox mixture MIX2 not be set,
the computer will give only the FO2 value of the primary
mixture.
2 Water temperature recorded during the dive at the maxi-
mum depth, given in °C or °F.
3 Surface interval given in hours and minutes.
4 The use of a safety factor (SF1/2) during a dive in
program.
To view the previous dive recorded in the logbook, depress
and hold button C ( ); in a rapid sequence you can view to
the first logbook display mode relating to the previous dive.
By depressing and holding button A (
rapid sequence to the first logbook display mode relating to
the immediately subsequent dive.
Relating topics:
• 2.3.1. - program parameters setting.
• 2.5.3. - Units of measure setting.
• 2.5.2. - Date and hour adjustment.
• 3.1. - AIR DIVE.
• 3.4.1. - Ascent rate.
program: if an air dive,
), you will enter into a
186
• 3.2. - NITROX mixtures dive.
• 3.3.4. - CNS toxicity display.
• 3.3.5. - PO2 alarms.
• 3.6. - program.
• 4.1.1. - Surface interval.
4.1.3. – Dive historic memory (
Archimedes II computer is equipped with a dive history
memory for both and
( ) function. In order view this function, depress repea-
tedly button B (Mode), until the (
UFDS display UFDS (picture 31). The program will display the
following information:
1 total time of all dives carried out, in hours;
2 maximum depth reached during all dives (given in meters
or feet);
3 total number of dives, given by the "DIVE" icon.
The ( ) function is able to store up to 999 dives, after
which it will cancel the memory and restart from zero. This
value may be modified by means of the (optional) interface
software.
Related topics:
• 2.5.3. - Units of measure setting.
• 3.1. - AIR DIVE.
• 3.2. - NITROX MIXTURES DIVE.
• 4.1.5. - Data PC transfer: compatible PC interface.
).
program dives; this is the
) icon appears on the