Navigation Settings - Blaupunkt BREMEN 975 Manual De Instrucciones

3
Information about the current route and position
Showing/hiding information
Note:
You can select the displayed information yourself
(see the section "Navigation settings", Settings for
visual instructions option).
4
Tapping on the map to determine a destination on
the map
Note:
For a planned route, you have the following options:
ƒ Replacing the existing destination with a new des-
tination.
ƒ Planning the new destination as interim destina-
tion of the route.
ƒ Planning the new destination as nal destination
of the route.
5
Name of current street
6
Opening the navigation menu
Determining the destination on the map
1 2
8 7
This map view features the following functions and
displays:
1
Toggling 2D/3D map view
2
Changing the map orientation
3
Displaying address and GPS information about the
current cursor position
4
For 3D map view only: Changing the tilt of the 3D
map view
5
Tapping on the map to reposition the cursor
6
Accepting the current cursor position as destination
7
Showing additional options:
ƒ Points of interest in the vicinity of the cursor
ƒ Save as favourite
ƒ Show cursor position
8
Zoom in/out

Navigation settings

The menu for navigation settings features the following
functions and settings:
Audio and warnings: Settings for navigation an-
ƒ
nouncements and warnings (e.g. of speed limits,
warning points such as sites of serious accidents and
school zones and referenced to tra c signs, e.g. for
curves and intersections)
Customise quick access: De ning entries of the
ƒ
quick access menu
ƒ Managing driving times (truck version only): De n-
ing driving times and breaks as well as correspond-
ing noti cations
Tra c: Adjusting TMC settings and use of earlier
ƒ
tra c data (e.g. concerning tra c jams)
ƒ Route Settings: Settings for the route planning (e.g.
type of vehicle, navigation mode, route planning
method and types of sections to avoid)
User Pro les: Changing and renaming user pro le
ƒ
ƒ Note:
ƒ The user pro le is based on your individual settings.
3
You can create up to four di erent pro les. When
changing to a di erent pro le, the application is re-
started. If this pro le has not been used previously,
the con guration wizard is called up at the start of
the application.
ƒ Map Settings: General settings for the map view
Settings for Visual Instructions: Settings for the
ƒ
display of information in the map view
ƒ Display: Settings for menu animations and daylight/
nighttime mode of the display
Regional: Settings for the programme language as
ƒ
well as units of measure and formats
ƒ Trip Overview: Settings for storing trips and routes
ƒ Protocol Storage: Settings for storing and transfer-
ring user and GPS data
Con guration Wizard: Starting the con guration
ƒ
6 5 4
wizard
ƒ Reset to Default: Deleting individual settings and
restoring the factory settings
Navigation
55