Environmental Protection; Technical Specifications - Metabo MAG 32 Instrucciones De Manejo

en ENGLISH
9. Accessories
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating instruc-
tions.
See page 4.
A Core drill with 19 mm Weldon shank, HSS/HM
B Centring pin, short,
HSS: for 30 mm cutting depth
HM: for core drill bit diameter 14-17 mm
C Centring pin, long,
HSS: for 55 mm cutting depth
HM:0 for core drill bit diameter 18-100 mm
D Morse taper for chuck with female taper
E Key-type chuck with female taper
F Metal drill bit
G Quick replacement system MK2 on Weldon,
19 mm
H Industrial holder MK2 on Weldon, 19 mm
I Securing belt with ratchet
J Universal cutting spray
K Weldon adapter, 19 mm, on thread ½" x 20 UNF
L Geared chuck with thread ½" x 20 UNF
M Adapter Weldon, 19 mm, on Fein Quick In
For a complete range of accessories, see
www.metabo.com or the main catalogue.
10. Repairs
Have your power tool repaired by a qualified electri-
cian. This power tool complies with the applicable
safety regulations. Repairs must only be carried out
by qualified electricians and using original spare
parts; otherwise the user faces a risk of accidents.
Any Metabo power tool in need of repair can be sent
to one of the addresses listed in the spare parts list.
Please attach a description of the fault to the power
tool.

11. Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that can
be recycled.

12. Technical specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
T = Tool attachment
M = Max. torque
D = Max. diameter (core drill bit)
max, K
D = Max. diameter (spiral drill bit)
max, S
D = max. diameter (tap)
max, T
P = Nominal power input
1
P = Power output
2
n = Speeds at rated load
0
H = Max. stroke
max
10
H = Height (incl. motor) with slide plate in
u
bottom position
H = Height (incl. motor) with slide plate in top
o
position
A = Dimensions of magnetic flux
m = Weight without mains cable
Wear ear protectors!
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).