Maintenance; Replacing The Batteries And The Internal Fuses; Cleaning The Instrument; End Of Life - HT IRONMETER Manual De Instrucciones

5. MAINTENANCE

 Only expert and trained technicians should perform maintenance
operations. Before carrying out maintenance operations, disconnect all
cables from the input terminals.
 Do not use the instrument in environments with high humidity levels or
high temperatures. Do not expose to direct sunlight.
 Always switch off the instrument after use. In case the instrument is not to
be used for a long time, remove the battery to avoid liquid leaks that could
damage the instrument
5.1.

REPLACING THE BATTERIES AND THE INTERNAL FUSES

When the display shows
Replacing the battery
1. Turn the rotary switch to OFF.
2. Remove the cables from the input terminals.
3. Loosen the fastening screw of the battery compartment cover on the top rear part of
the instrument and remove the cover.
4. Remove all batteries and replace them with new batteries of the same type (see §
6.1.2), respecting the indicated polarity.
5. Restore the battery compartment cover into place and fasten it by means of the
relevant screw.
6. Do not scatter old batteries into the environment. Use the relevant containers for
disposal.
Replacement of fuses
1. Position the rotary switch to OFF and remove the cables from the input terminals.
2. Loosen the fastening screw of the fuse compartment cover under the instrument
stand and remove the cover.
3. Remove the damaged fuse, insert a new fuse of the same type (see § 6.1.2) and close
the fuse compartment again.
5.2.

CLEANING THE INSTRUMENT

Use a soft and dry cloth to clean the instrument. Never use wet cloths, solvents, water, etc.
5.3.

END OF LIFE

WARNING: the symbol on the instrument indicates that the appliance and its
accessories must be collected separately and correctly disposed of.
s internal circuits.
'
it is necessary to replace the battery.
" "
EN - 14
CAUTION
IRONMETER
s
'