Special Safety Instructions - RK Rose+Krieger DuoLine S Instrucciones De Montaje

5.2 Special safety instructions

•
Work with the linear unit may only take place in accordance with these instructions.
•
The appliance may only be opened by authorised technical staff. In the event of a defect in
the linear unit, we recommend that you contact the manufacturer or send in this linear unit
for repair.
•
An electric drive may only be connected to this linear unit by the appropriate technical staff,
in observance of the local connection conditions and regulations (e. g. DIN, VDE).
•
Electrically operated attachments may only be connected to this linear unit by the relevant
experts, in compliance with the local connection conditions and regulations (e.g. DIN, VDE).
•
Motor current monitoring for enhanced safety: Monitoring the motor current enables faults
to be detected immediately and to prevent hazards originating from the system.
•
Wear the necessary personal protective equipment (PPE) at all times during work.
•
Persons remaining in and reaching into the danger zone of the linear unit when in operation
is forbidden.
•
Unauthorised modifications or changes to the linear unit are not permitted for safety reasons.
•
If the linear unit is installed in an oblique or vertical position, the guide carriage must be
secured to prevent slipping during work (installation, dismantling, maintenance, servicing).
•
The transverse forces, torques and speeds specified by RK Rose+Krieger GmbH for this linear
unit must not be exceeded. In dynamic operation, this must be considered for the version: Fx
2
max = m*a [m/s ].
•
The movement of the linear axis must be limited using technical means in such a way that the
guide carriage is prevented from running into the limit positions.
In the event of damage (e.g. power failure), check the operation of all safety-related elements
(controllers, limit switches etc.).
•
Following a collision, the toothed belt, track rail guide and carriage have to be replaced - even
if there is no visible damage. Spare parts information is to be taken from the spare parts list
for the relevant linear unit type.
•
Following a collision, the tapped spindle, guide nut, track rail guide and carriage have to be
replaced - even if there is no visible damage. Spare parts information is to be taken from the
spare parts list for the relevant linear unit type.
•
The rating plate must remain legible. It must be possible to identify the data effortlessly at any
time.
•
Safety-relevant hazard symbols identify danger areas on the product.
•
Safety-relevant devices must be inspected at regular intervals, but at least once a year, for
proper function, damage and completeness.
5. Safety 5. Safety 5. Safety
55 55 55