MAG MG3000 Instrucciones De Uso página 60

2 Place an appropriate container under the oil draining hole to collect the
drained gasoline.
3 Using a screwdriver, loosen the carburetor draining screw. Gasoline will
begin streaming from the carburetor draining hole. Once all of the gasoline is
drained, tighten the draining screw again.
4 Remove the spark plug (see page 26) and pour a tbsp of clean motor oil (10
~ 20 ml) in the cylinder. Pull the startup handle gently, this will make the
engine spin and distribute the oil. Then install the spark plug again.
5 Pull the starter rope slowly until you feel resistance. In this point, the piston is
rising in its compression stroke and the intake and exhaust valves are closed.
This position helps protecting the engine against internal corrosion.
OIL DRAINING
DRAINING SCREW
STARTUP HANDLE
26