Evd Version - Wega LEVA Manual De Uso

5.6 EVD VERSION

Dispensing coffee
• put the coffee cup under the dispensing spout;
• press the desired dose key: wait for dispensing to finish (LED comes on);
• to stop coffee delivery in advance, press the delivery key again or press the STOP key;
• if the push button panel malfunctions or is locked, use the manual switch.
Programming
• Place the programming lever (1) in the ON position. It is located under the front
right-hand panel of the body;
• put the coffee cup under the dispensing spout.
• press the PROG/STOP key (2) and all dose key LED will come on;
• press the desired dose key (3);
• when the desired dose has been attained, confirm by pressing the PROG/STOP key (2);
• repeat this operation for the other dose keys.
• upon completion of programming, place the programming lever (1) back in the OFF
position.
3
In other models to access programming it is necessary to use a special key switch.
To exit programming it is sufficient to wait a few seconds.
NOTE
The programming of every dose must be done with ground coffee and not with previously used grounds.
With machines having two or three groups, by fi rst programming the right-hand push buttons the others are automatically
programmed. It is however both possible and advisable to program the push button panels independently, always starting
from the right-hand push button panel.
espresso coffee machine - instructions for the user
2
3
2
3
R
1
STOP
PROG
2
69
english