Evd Version - Wega ALE Manual De Uso Y Mantenimiento

6.6.4 EVD version

PROGRAMMING
The machine is programmed
by default. Should the coffee
doses need to be modified, pro-
ceed as follows:
• Always programme the right
ROSSO
C:0 M:100 Y:100 K:0
NERO
C:0 M:0 Y:0 K:100 hand push-button panel first.
VERDE
C:100 M:0 Y:100 K:0
In this way all push-button
panels get automatically pro-
grammed. If necessary, sub-
sequently programme the
others;
• place the programming le-
ver (X) (See note *) located
under the boiler cover of the
machine, in the ON position;
• put the coffee cup under the
dispensing spout;
• press button
5 seconds, until all leds of the
dose buttons are lit;
• press the wanted dose but-
ton, for example
• to confirm the dose, press
button ;
• repeat this operation for the
other dose buttons;
• when finished programming,
return the programming lever
(X) (See note *) to the OFF
position.
Programming of every dose must be carried out with ground coffee
and not with previously used coffee dregs.
50 216
of
for at least
;
*
NOTE ( )
• In some models, there is no programming lever X; to
access programming, press the key
seconds with all push button panel LED on. To con-
firm the dose press the
key again.
• In other models, to access programming it is neces-
sary to use a special key switch.
• To exit programming it is sufficient to wait a few
seconds.
X
EXAMPLES OF PUSH BUTTON PANELS INSTALLED ON THE MACHINES
COFFE DISPENSING
• Put the coffee cup under the
dispensing spout;
• press the desired dose key, for
example
coffee to be dispensed (LED
comes on);
• to block the dispensing of
coffee in advance, press but-
ton again or button
• in the event of anomalies or
if the push button panel is
locked, use the manual switch
(see EPU version).
Do not remove the filter-holder from
the delivery group during coffee
dispensing
key or the selected dose
and wait for the
;
for at least 5
USER manual