Skil CR540601 Manual Del Propietário página 21

i. Allow the blade to reach full speed, then guide the saw into the workpiece and make the
cut.
j. Release the trigger switch and allow the blade to come to a complete stop.
k. Lift the saw from the workpiece.
NOTICE: Do not bind the blade in the cut.
Plunge Cuts (Fig . 15)
WARNING
making a plunge cut. Attempting a plunge
cut at any other setting can result in a loss
of control of the saw, which can result in
serious injury.
a. Detach the battery pack from the tool before
making any adjustment.
b. Adjust the depth of cut according to the
thickness of the material to be cut.
c. Attach the battery pack.
d. Holding the main handle of the saw with one
hand, tilt saw forward and rest front of the
foot plate on material to be cut. Line up the
saw line indicator with the line you've drawn.
e. Raise the lower guard using lower guard lift lever and hold the front of the foot plate with
the other hand.
f. Position the saw with the blade just clearing the material to be cut. Start the motor and
once fully up to speed, gradually lower the back end of saw, using the front end of the foot
as a hinge point.
WARNING
hold the auxiliary handle.
g. Proceed cutting in forward direction to end of cut.
WARNING
WARNING
h. Turn the saw around and finish the cut in the normal manner, sawing forward.
i. If corners of your plunge cut are not completely cut through, use a jigsaw or hand saw to
finish the corners.
Always adjust the bevel
setting to zero before
Once the foot plate rests flat on the surface being cut, release the
lower guard and move the hand holding the front of the foot plate to
Allow blade to come to a complete stop before lifting the saw from
cut.
Never pull the saw backward, since blade will climb out of the
material and KICKBACK will occur.
Fig. 15
21