Installing The Projector - Sony VPL-S500U Manual De Instrucciones

Installing the Projector

Horizontal center
of the screen
The distance between the lens and the screen varies depending on the size of the
screen. Use the following table as a guide.
The following table shows the projection distance when the Macintosh 16-inch mode
signal (horizontal 832 × vertical 624 dots) is input.
• When XGA signal is input, the projection distance becomes longer by 1.5%.
• When S VGA (800 × 600 dots) or video signal is input, the projection distance
becomes longer by 4%.
• When VGA (640 × 480 dots) signal is input, the projection distance becomes longer
by 30%.
Screen size (inches) 40
Minimum 1.5 (4.8) 2.3 (7.4) 3.0 (10.0) 3.8 (12.5) 4.6 (15.1) 5.8 (18.9) 7.0 (22.8) 7.7 (25.4) 9.7 (31.8) 11.6 (38.2)
Distance
Maximum 2.2 (7.2) 3.3 (10.9) 4.5 (14.6) 5.6 (18.3) 6.7 (22.0) 8.4 (27.6) 10.1 (33.2) 11.3 (36.9) 14.1 (46.2) 16.9 (55.5)
For detailed information on installation measurements, see page 30 (EN).
This section describes the installation arrangements for installing the
projector on a table. For ceiling installation, consult with qualified Sony
personnel (see page 31 (EN)).
60 80 100
Adjust the vertical and horizontal positioning of the
projector.
Vertical positioning (side view)
Adjust the height of the projector so that the center of
the lens is just below the bottom edge of the screen.
Horizontal positioning (top view)
Adjust the horizontal positioning of the projector so
that the lens is aligned with the horizontal center of the
screen.
120 150 180
Unit: m (feet)
200 250 300
13
(EN)