Error Message - effegibi Logica Manual De Uso

TROUBLE-SHOOTING
Please note: the information in the table below and the action to take is intended for the use of the
assistance centre personnel and others qualified to install/maintain the equipment.

Error message

Error 1
Error 2
Error 3
Error 4
Error 5
Error 6
For any situations not covered in this table, consult your approved assistance centre or contact the company
direct.
The data and features referred to are not binding on EFFEGIBI and the company reserves the right to make any appropriate changes
OPERATING AND MAINTENANCE MANUAL FOR LOGICA
Meaning
No
dialogue with an
element
recognised.
The control panel is
not in dialogue with
the other electronic
elements.
Boiler full too soon.
Boiler not yet full.
Boiler not
empty.
New peripheral
device recognised.
without having to give prior notice or replace this manual.
Error
software Lack of
communication
already with 1 or more
devices.
Lack of
communication
with 1 or more
devices.
The boiler filled
too quickly during
initial rinsing
final emptying.
The boiler didn't
fill within the
prescribed time
limit during initial
rinsing or final
emptying.
yet The water level in
the boiler remained
too high for too
long during initial
rinsing or final
emptying.
Cause
One of the devices is 1. Check the device
not receiving power connections.
or is not connected. 2. Run the start-up
sequence.
One of the devices is 1. Check the device
not receiving power connections.
or is not connected. 2. Run the start-up
sequence.
Outlet valve not 1. Check that the
working. outlet path is clear.
or 2. Check that the
steam pipe is not
obstructed, bent or
is not siphoning.
3. Clean the outlet
valve.
Lack of water in 1. Check that the
the system or the water tap is turned
inlet valve filter is on.
blocked. 2. Check that there
is
system.
3. Check that the
filter at the entrance
to the inlet valve is
not blocked.
Outlet valve not 1. Check that the
working. outlet path is clear.
2. Check that the
steam pipe is not
obstructed, bent or
is not siphoning.
3. Clean the outlet
valve.
A new component 1. Check
has been connections and
connected to the power cabling.
product. 2. Run the start-up
sequence.
EN
Solution
water in the
33