EN
13.
SAUNA TROUBLE-SHOOTING
If there is a problem with the system, the sauna is switched off and the "Sauna" icon starts flashing, as shown
below.
PROBLEM
Panel stays off
Internal light/colour-therapy
doesn't work
Heater doesn't heat up
14.
TRANSPORT AND HANDLING
34
The data and features referred to are not binding on EFFEGIBI and the company reserves the right to make any appropriate changes
OPERATING AND MAINTENANCE MANUAL FOR LOGICA
CAUSE
- No electric current
- No power feed
Connector not plugged in
The safety thermostat has
intervened
Contact an approved service centre or the company direct for anything not covered by the
above table.
Never, under any circumstances, attempt any repair work that is not included in the "SOLU-
TIONS" column of the above table.
All repair work must be carried out by an approved service centre or by the manufacturer.
If it is necessary to move a Home Spa product within the same room or to another room,
it must be dismantled and reassembled following the instructions accompanying the
product for initial assembly.
Never, under any circumstances, lift a fully assembled Home Spa product manually or
using lifting equipment.
without having to give prior notice or replace this manual.
SOLUTION
- Check the general electrical
distribution board and switch
Check the cable connection at the
back of the ceiling light fitting
1) Call the technical help line
2) Check that the stones are not
positioned in a way that obstructs
the air circulation inside the heater.