English
coffee will be light and without the froth that marks a good cup of espresso. If the coffee is ground too
finely the espresso will be dark and strong and have little froth.
We recommend grinding the coffee beans with a traditional grinder (not a grinder that uses a blade) imme-
diately before you make the coffee since the coffee quickly loses its aroma after it is ground.
A prewarmed cup helps keep the espresso at the right temperature. We recommend placing the cups on
the cupwarmer (2) before use.
When the machine is on the stand-by mode and it's not working, you'll see the led of the front panel go
on in a sequential way.
11.2.1.1 – PROGRAMMING THE COFFEE DOSES
With this machine it's possible to program two different coffee doses of water in order to obtain one or
two cups of coffee. In order to set the water doses and memorize them for future use, follow the present
instructions:
a) Insert the one cup filter (9) or two cup filter (10) in the filter holder (8).
b) Remuve the filter-holder (8), fill the filter with one or two measures of ground coffe (one measure per
cup).
c) Press well the coffee in the filter holder with the use of the coffee presser (12).
d) Place the filter holder (8) under the brewing group (5) turning it from the left to the right with strength.
After these operations please act as follows:
1. Press the programming switch (20) for 5 seconds till the led will start to blink. The symbol of the switches
21 and 22 will go on at the same time.
2. Once you have placed the one cup filter, press the switch (21) and let the coffee come out.
3. Press again the same switch (21) once you get the desired coffee quantity.
4. The water dose programmed for one coffee will be memorized on the switch (21) and the relative led
will go off.
5. Repeat the operations described under point 3 & 4 in order to program the water dose for the switch (24).
6. Each customer is free to program the water doses of the switches (21) and (22)in order to obtain a
stronger or smoother coffee using the one or two cups filter.
7. After the doses have been memorized, press again the switch (20) "MENU" in order to end programming.
8. The switches led will start to go on again in a sequential way. The machine will then be ready for
dispensing excellent coffees.
Warning: the coffee emerges from the spout of the portafilter at a temperature
of 75-85°C. Exercise caution to avoid burns.
Remove the cups from the cup rest and serve immediately.
BUONDI_PUCCINO_2010.indd 42
42
15/01/10 15.39