Capacitance Measurement - HT 60 Manual De Instrucciones

4.3.6. Capacitance measurement

Before carrying out capacitance measurements on circuits or capacitors, cut
off power supply from the circuit being tested and let all capacitance in it be
discharged. When connecting the multimeter and the capacitance to be
measured, respect the correct polarity (when required).
Fig. 7: Use of the instrument for Capacitance measurement
Select position CAP
1.
2. Press the MODE key until the symbol
Insert the red cable into input terminal VHz%CAPTemp 
3.
into input terminal COM.
4. Press the REL button before carrying out measurements.
5. Position the leads at the ends of the capacitor to be tested, respecting, if necessary,
the positive (red cable) and negative (black cable) polarity (see Fig. 7). The display
shows the value of capacitance.
6. The message
measurable value.
7. To use the HOLD function and Relative measurement, see § 4.2
O.L. indicates that the value of capacitance exceeds the maximum
" "
CAUTION
nF is displayed.
" "
EN - 13
HT60
and the black cable