Initial Setup - Respironics UltraFill Manual Del Usuario

Using the UltraFill System

Initial Setup

1. Place the UltraFill system in an appropriate area (see the Specification section of this manual).
2. Place the UltraFill in a room with adequate ventilation. The sides and rear of the device must be at least 24 inches
away from any object.
3. Plug the UltraFill in to a standard 120V outlet. Do not connect the UltraFill System to an electrical outlet
controlled by a wall switch or ground fault interruptor. Make sure that no other high power device such as a
TV, stereo, computer, refrigerator, microwave oven, electrical range, or other large appliance is connected to this
outlet.
Connecting an Oxygen Concentrator
Warning: to prevent an accidental tip over, do not attempt to move the UltraFill when it is connected to a cylinder.
Note: the oxygen concentrator used with the UltraFill System may look different from the illustration.
1. Ensure that one end of the tubing is connected to the transfill outlet connection.
2. Connect the other end of the tubing to the concentrator outlet connection.
10
Concentrator Tubing Connection
2
Transfill Tubing Connection
1