Features; Quick-Disconnects - Gaymar Medi-Therm III Manual Del Operador

Medi-Therm III
®

3.0 Features

Please familiarize yourself with the location and purpose
of the features (fig. 2) before reading the start‑up
procedures or attempting to operate the Medi-Therm III
Machine.
Water Fill Opening
Lift cover. Fill unit with distilled
water until green band on
float is fully visible (p. 6)
Operating Instructions
& Precautions
Condensed instructions are located
on the cover of the water fill opening
and on the rear-facing side of the
Operator Control Panel's sloped
surface.
Figure 2—Medi-Therm III features
Features
Operator Control Panel
Identifies displays, indicators, and
controls used in Medi-Therm III
operation (pp. 4-5).
Patient Probe Jack
Accepts patient probe plug
connecting patient probe to
machine (pp. 10, 12). Use
only Gaymar probes or
equivilent YSI 400 series
probes approved for use with
medical devices.
Dual Blanket/Body Wrap
Connections & Probe
Check Well
Quick-disconnects facilitate
connection to water supply (p. 6).
PROBE CHECK well verifies patient
probe (p. 17).
ON/OFF Switch
(Circuit Breaker)
Controls power to
Medi-Therm III.
3