Adjusting The Headlight Beam; Replacing The Motorcycle Computer Battery (250-300 Sef/R) - SHERCO 250 SEF Manual De Propietario

250-300 SEF/R
Electrical system maintenance (continued)

ADJUSTING THE HEADLIGHT BEAM

1
REPLACING THE MOTORCYCLE COMPUTER BATTERY
(250-300 SEF/R)
1
2 2
120
The headlight beam is adjusted with the
motorcycle in a state of operation with its driver
seated on the saddle.
To set the headlight beam, tighten or loosen the
screw at the base of the headlight housing.
Tightening the screw
beam.
Loosening the screw
beam.
Remove the headlight housing (
Remove the turn
1
access the motorcyle computer screws.
Remove the screws
ter to get it out of the way.
Disconnect the main connector from the computer.
Open the computer with a coin and remove the
battery.
Install a new battery (with the marking up).
Computer battery CR 2032
- Replace the cover, taking care not to damage
the O-ring.
- Plug the main connector into the computer.
- Install it on the bike and check to make sure
the meter works.
- Reinstall the computer support.
- Install screws and replace the turn signal
2
flasher.
- Replace the headlight housing (
- Set the computer (
☛
raises the headlight
1
lowers the headlight
1
p.118).
☛
signal flasher in order to
and remove the compu-
2
p.119)
☛
p.81)
3V