Evolution HULK PETROL COMPACT24HP Manual De Instrucciones página 16

Fig. 6
Fig. 7
Fig. 8
16
• Press the engine ignition rocker switch to the 'ON'
(I) position. (Fig. 6)
• Set the throttle lever to maximum. (Fig.7)
Note: The throttle can normally be left in this position
at all times.
• Steady the Hulk by holding the operating handle at
a convenient point.
• Use your other hand to grip the recoil starter cord
handle. (Fig. 8)
• Pull the recoil starter cord slowly until resistance is
felt indicating that the starter is engaged.
• When resistance is felt pull the cord sharply.
• Continue this procedure until the engine starts.
• Allow the engine to achieve operating temperature.
• Usually the choke can be returned to the 'off'
(run) position almost immediately when the
engine fires up, but this will depend upon ambient
temperatures, operating conditions etc. and
operator discretion will be required.
• Under some circumstances choke may be needed
even when the engine is warm from a previous
operating cycle. If you experience difficulty in
starting a warm engine:
• Set the choke to the 'on' position.
• Pull the recoil starter once.
• Return the choke to the 'off' (run) position.
• Pull the recoil starter until the engine fires.
• Note: The Hulk will begin to vibrate and travel as
soon as the engine is started. The operator should
ensure due diligence when starting this machine.
Stopping your Hulk Petrol Engine
• Press the engine ignition rocker switch to the 'OFF'
(0) position.
• Close the fuel tap.
www.evolutionpowertools.com