Armrest Receiver Attachment; Padded Swing-Away Armrests - Sunrise Medical Quickie Q2 Lite Manual De Instrucciones

Ocultar thumbs Ver también para Quickie Q2 Lite:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Q UI C KI E 2 L ITE
K. ARMREST RECEIVER ATTACHMENT
Mounting
1. Place the two clamp receivers (A) over the top portion of the rear side frame tube .Align with the
single post height-adjustable armrest.
2. Pinch both clamp receivers together at the armpost receiver side and insert into the armpost
receiver .
3. Once inserted, pinch both clamp receivers together on the far side of the armpost receiver.
4. Hold both clamp receivers against the top portion of the rear side frame tube and fasten(C) .
Adjustment
1. To adjust the fit of the Single Post Armrest in the receiver, loosen the 4 set screws
(D) by using a 5/64" Hex Key .
2. With the armrest assembly in the receiver (B), press firmly on the outside of the
receiver.
3. Maintain pressure on the receiver and re-tighten two of the set screws (D).
4. Remove the armrest assembly and re-tighten the remaining two set screws.
5. The armrest will fit firmly in the receiver and lessen any noise that may result from
vibration.
L. PADDED SWING-AWAY ARMRESTS
Swing-away armrests (F)can be detached or can swing away to allow lateral transfers. They are height adjustable
(1" increments) by moving bolt (E) up or down in predrilled holes on armrest bracket.
Additional height can be achieved by removing bolts (G), flipping and rotating the receiver to opposite (H).
Ensure bolts (G) are retightend.
Swing-away, removable armrests are installed by sliding armrest into receiver (H) on back frame.
MK-100071 Rev. E
43
44
45
46
47
24
IX. DEALER SERVICE AND ADJUSTMENT
43
44
45
46
47
F
E
H
G

Publicidad

Tabla de contenido
loading

Tabla de contenido