K312I, K318I, K525I, K624I And K1050 Moak - KAHLES K4i Manual De Instrucciones

6.2 b Reset to factory conditions (full elevation of the
vertical adjustment) on K312i, K318i, K525i,
K624i and K1050 MOAK
1. Turn the elevation turret (5) in the up direction until you
reach the mechanical stop.
2. Use the supplied allen key to loosen the two set screws
1– 3 turns (do not remove the set screws completely)
until you have a free moving turret without clicks.
3. Now turn the elevation turret in the up direction until you
reach the mechanical stop.
4. Use the short end of the supplied allen key to tighten the
two set screws to approximately 1 Nm or 8 inch
pounds.
5. Turn the elevation turret in the down direction until you
reach the mechanical stop.
6. Use the supplied allen key to loosen the two set screws
1– 3 turns (do not remove the set screws completely)
until you have a free moving turret without clicks.
7. Now turn the elevation turret in the down direction until
you reach the mechanical stop.
8. Use the short end of the supplied allen key to tighten the
two set screws to approximately 1 Nm or 8 inch
pounds.
9. You have now deactivated the zero stop feature. Your
rifle scope will now have full adjustment travel.
NOTE: The mechanical (physical) stop will be about 3 or
4 clicks below zero. This allows adjustments slightly below
zero for special conditions as increased temperature or
closer targets.
Pay attention, never use any strong force when you do any
adjust ments on the turrets.
E
25