Connections - Teac AD-850 Manual Del Usuario

Complete all other connections before turning the unit
V
on.
o Read the instructions of each device that you intend to use with
this unit .
o Be sure to connect each plug securely . Do not bundle connecting
cables with power cords . Doing so could cause noise .
AD-850 (back side)
Amplifier
LINE LINE
OUT IN
Tuner, etc.
Example
Notes on turning on or off the power
When an amplifier is connected to the unit, turn on or off the power
of the unit and the amplifier in the following sequence .
When turning on the power
1 . This unit
2 . Amplifier
When turning off the power
1 . Amplifier
2 . This unit
16

Connections

Wall socket
Speakers
A
LINE IN/OUT connectors
These connectors transmit an analog 2-channel audio signal .
Connect the components using the included RCA audio cables .
Connect a stereo amplifier, mixer or other equipment to this
unit's analog audio input and output connectors .
Use the included RCA audio cables (or commercially-available
ones) for connections .
Connect this unit's R input connector to the R output connector
of the audio output device, and this unit's L input connector to
the L output connector of the other device .
White (L)
Red (R)
This unit
B
AC Power Cord
After all other connections are complete, connect the plug to an
AC wall outlet .
Be sure to connect the power cord to an AC outlet that
supplies the correct voltage .
Hold the power plug when plugging it into an outlet or
unplugging it . Never pull or yank on the power cord .
White (L)
Red (R)
Amplifier, etc .