Wet Vacuum Cleaning - Kärcher NT 30/1 Tact Te H Manual Del Usuario

 Pull disposal bag over the container.
Ensure that the marking line is within
the container and the ventilation hole is
positioned on the back wall of the con-
tainer.
 Insert and lock the suction head.

Wet vacuum cleaning

DANGER
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Close the suction connection
Illustration
 Precisely fit the plug into the suction
connection.
 Insert the plug up to the stop.
Removing the safety filter sack
 Release and remove the suction head.
Illustration
 Pull safety filter bag on the flange up
and out.
 Close tightly the opening of the suction
connection of the safety filter sack using
the closing lid.
Illustration
 Pull over the safety filter sack.
Illustration
 Take off the protective film and close
the ventilation hole (1x NT 30/1 - 2x NT
40/1, NT 50/1) with a self-adhesive tab.
 Securely close the safety filter bag with
the attached cable tie.
 Remove the safety filter bag.
 Wipe the inside of the container using a
damp cloth.
 Dispose of the safety filter bag in a dust-
tight bag according to the statutory pro-
visions.
 Insert and lock the suction head.
– To suck wet dirt, always remove the
safety filter bag.
Removing the dust disposal bag
Illustration
 Release and remove the suction head.
 Put the disposal bag over.
 Take off the protective film and close the
ventilation hole with a self-adhesive tab.
 Tightly close the disposal bag with ca-
ble tie underneath the opening.
 Remove disposal bag.
 Wipe the inside of the container using a
damp cloth.
 Dispose of the disposal bag according
to the local provisions.
 Insert and lock the suction head.
– To suck wet dirt, always remove the dis-
posal bag.
Drain off dirt water
NT 50/1 only:
Illustration
 Drain off dirty water through the drain-
age hose.
General
WARNING
The flat pleated filter must always be in
place while vacuuming.
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
– 4
EN 21