Start up
Warning
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
Dry vacuum cleaning
The device is fitted with a paper filter
–
bag with locking slide, order no. 6.904-
406.0 (10 pcs).
Note:You can use this appliance to vacu-
um all types of dust up to dust class L. It is
statutorily necessary to use a dust collec-
tion bag (see Filter systems for order
number).
Note:The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values greater
than or equal to 1 mg/m
Caution
The flat pleated filter must must always be
in place while vacuuming.
To vacuum fine dust, you must use an
–
additional paper filter bag or a fleece fil-
ter bag.
Installing the paper filter bag/fleece filter bag
Illustration
Release and remove the suction head.
Place the paper or fleece filter bag.
Insert and lock the suction head.
.
3
EN
Wet vacuum cleaning
Warning
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
Remove the brush strips.
Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag/fleece filter bag
Illustration
Release and remove the suction head.
Pull the paper filter bag/fleece filter bag
towards the rear.
Pull the locking slide up and seal the pa-
per filter bag/fleece filter bag tightly
when removing it.
Dispose of the used paper filter bag/
fleece filter bag according to the local
provisions.
Insert and lock the suction head.
To vacuum wet dirt, first remove the pa-
–
per or fleece filter bag.
General
Caution
The flat pleated filter must must always be
in place while vacuuming.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the
–
electrodes with a brush. Clean the con-
tainer with a damp rag and dry it.
– 3
15