Dry Vacuum Cleaning; Blowing Function; Wet Vacuum Cleaning; Finish Operation - Kärcher A 2656 X plus Manual Del Usuario

Dry vacuum cleaning

Illustration
See also illustration 12
For a dust-free disposal of the vacuuming ma-
terial we recommend to insert the paper filter
bag as well. This provides the additional ad-
vantage that the cartridge filter will not be-
come contaminated that quickly.
Work only with a dry cartridge filter!

Therefore: Always let the cartridge filter
dry thoroughly before using it!
Added filter bags can burst!

Therefore: Change the filter bag at the
appropriate time!
Always use a filter bag while sucking
in fine dust!

The filling level of the filter bag depends
on the dirt that is sucked in.
The filter bag needs to be replaced more
frequently while sucking in fine dust, sand,
etc.

Please use the pre-separator accessory
(order no.2.863-139) to such in ash.
Vacuuming hard surfaces
Illustration
Use your foot to press the reversing switch of
the floor nozzle. The brush strips at the bot-
tom of the floor nozzle are extended.
Vacuuming carpeted floors
Illustration
Use your foot to press the reversing switch of
the floor nozzle. The brush strips at the bot-
tom of the floor nozzle are retracted.
Note: Due to the high cleaning power of the
appliance the suction nozzles may get sucked
in excessively when working on carpets, up-
holstery, curtains, etc. In this case, use the
manual vacuum slide on the handle to reduce
the cleaning power. Close again after use.

Blowing function

Use this function, for example, to blow out
leaves or dust from the garage, hobby room,
work shop, courtyard or garden.
Illustration

Connect connection hose. Open the slide
of the air regulation, and select the de-
sired blowing performance.
All manuals and user guides at all-guides.com
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes the
suction opening and the appliance works at a
higher speed. Switch off the appliance imme-
diately and empty the container.
Illustration

Empty the container
Illustration

Illustration


Storing the Appliance
Illustration



- 3
EN

Wet vacuum cleaning

Caution:

Finish operation

Turn off the appliance and disconnect the
mains plug.
Press the unlocking mechanism by foot
and remove the vacuuming device from
the chassis.
Remove the motor casing and empty the
container.
Insert the vacuuming device in the chas-
sis - the container is self-locking.
Place the accessories in the appropriate
compartments at the appliance and store
the appliance in a dry room.

Transporting the device

The large wheels facilitate transportation
on stairs; hold the device at the transport
handle while doing so.
Note: Never transport the device at the
handle of the vacuuming device; risk of
tilting!
The device is to be fastened properly be-
fore transporting the device in the car.
Note: We recommend that you first re-
move the vacuuming device from the
chassis.
9