Wet Vacuum Cleaning; Interrupting Operation; Finish Operation; Maintenance And Care - Kärcher MV 4 Manual De Instrucciones

Wet vacuum cleaning

For vacuuming up moisture or wet-

ness pay attention to the correct
floor nozzle insert and connect the
corresponding accessories.
Caution:
Do not use a filter bag!
Immediately switch the appliance off if
foam forms or liquids escape!
Immediately switch the appli-
ance off or pull the power plug if
foam forms or liquids escape!
Do not use a filter bag!
Note: If the container is full, a float
closes the suction opening, and the ap-
pliance works at a higher speed.
Switch off the appliance immediately,
and empty the container.

Interrupting operation

Illustration
Turn off the appliance.

Illustration
Hook the floor nozzle into the park-

ing position.

Finish operation

Turn off the appliance and discon-

nect the mains plug.
Empty the container
Illustration
Remove the appliance head and

empty the reservoir filled with wet or
dry dirt.
Storing the appliance
Illustration
Store the accessories and the

mains cable on the appliance and
store the appliance in dry rooms.

Maintenance and care

Danger
Turn off the appliance and re-
move the mains plug prior to any
care and maintenance work.
Repair works may only be per-
formed by the authorised cus-
tomer service.
Warning
Do not use abrasives, glass or
universal cleaners! Never im-
merse the appliance in water.
Clean the appliance and accessory

parts made of plastic with a com-
mercial plastic cleaner.
If required, rinse the container and

accessories with water properly
and dry them before reuse.
Clean flat fold filter
Recommendation: Clean the filter
cartridge after every use.
Illustration
Unlock, fold out and remove the fil-

ter cartridge, empty dirt from the fil-
ter cartridge over a waste bin.
In order to clean the inserted flat

pleated filter, knock the filter car-
tridge against the edge of the waste
bin. It is not necessary to remove
the flat pleated filter from the filter
cartridge.
If necessary, clean the flat pleated
filter separately.
Illustration
Unlock, fold out and remove the fil-

ter cartridge.
Illustration
Remove the flat pleated filter from

the filter cartridge and tab it out.
– 10
EN 17