Optional Accessories; Applications; Preparation Before Operation - Hitachi C 10FC2 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English

OPTIONAL ACCESSORIES

q Extension Wing Assembly (Fig. 1) (Code No. 311495)
w Saw blade 10" (255 mm) TCT Saw blade for fine surface cut (Total teeth: 60) (Code No. 976472)
e Saw blade 10" (255 mm) TCT Saw blade for normal cut (Total teeth: 70) (Code No. 976473)
WARNING:
Using attachments or accessories not recommended in this manual can be dangerous
and cause personal injury or mechanical damage to the saw.

APPLICATIONS

Wood, plywood, color board, soft fabric board, hard board similar materials and aluminum sash.

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:
1. Installation
3/8" (10 mm), 4 Holes
19-11/16" (500 mm)
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8 mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 2" (50 mm) plus the thickness of the work bench.
For example, use 5/16" (8 mm) × 3" (75 mm) bolts fot a 1" (25 mm) thick work bench.
2. Locking and unlocking cutting arm in/from the down position
Carrying
Handle
Cutting
Arm
Lock
Position
10
...sold separately
8-21/32"
(220 mm)
Unlock
Position
Lock
Plate
Fig. 5
Base
Work Bench
Fig. 4
When transporting the power tool, the cutting arm should
always be locked in the down position. This can be
accomplished by lowering the cutting arm and moving
the lock plate to the locked position, as shown in Fig. 5.
Before operation, unlock the cutting arm from the down
position by moving the lock plate to the unlocked position.
For transportation purpose, grasp the carrying handle with
one hand and hold the base at the left end grip section
with the other hand to carry.
5/16" (8 mm) Bolt
5/16" (8 mm) Nut

Publicidad

Tabla de contenido
loading

Tabla de contenido