Hitachi C 10FC2 Manual De Instrucciones página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(2) Setting to cut crown moldings at positions w and e in Fig. 27 (see Fig. 30):
q Turn the table to the left and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
w Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings: 30°
* For 38° type crown moldings: 33.9° ( mark)
e Position the crown molding so that the lower surface (B in Fig. 26) contacts the fence as in Fig.
31.
q
Miter Angle Scale
Fence
A
8. Cutting easily-deformed materials, such as aluminum sash
5 mm
Wing Bolt
Wood Plate
Fig. 32
9. How to use the dust bag (Standard accessory)
Blade Guard
(Metal)
Dust Bag
Right
Angle
Fig. 33
Bevel
Angle Scale
r Fence
Base
Table
Fig. 28
B
Table on Base
Fig. 29
Materials such as aluminum sash can easily deform when
tightened too much in a vise assembly. This will cause inefficient
cutting and possible overload of the motor.
Vise
When cutting such materials, use a wood plate to protect the
Assembly
workpiece as shown in Fig. 32.
When cutting aluminum materials, coat the saw blade with cutting
oil (non-combustible) to achieve smooth cutting and a fine finish.
Wood
Plate
Aluminum
Sash
(1) When the dust bag has become full of sawdust, dust will be
blown out of the dust bag when the saw blade rotates.
Check the dust bag periodically and empty it before it becomes
full.
(2) During bevel and compound cutting, attach the dust bag at a
right angle to the base surface as shown in Fig. 33.
CAUTION:
Base Surface
Bevel
Angle Scale
w
e
Fence
Miter Angle Scale
Table
Fig. 30
Fence
A
B
Table on Base
Fig. 31
Empty the dust bag frequently to prevent the
duct and the blade guard (metal) from becoming
clogged.
Sawdust will accumulate more quickly than
normal during bevel cutting.
English
Base
19

Publicidad

Tabla de contenido
loading

Tabla de contenido