Protecting The Environment; Troubleshooting - DeWalt DWV010 Manual De Instrucciones

Protecting the Environment

Separate collection. This product must not be disposed of
with normal household waste.
Should you find one day that your D
replacement, or if it is of no further use to you, do not dispose of it
with household waste.
Separate collection of used products and packaging
allows materials to be recycled and used again. Re-use of
recycled materials helps prevent environmental pollution
and reduces the demand for raw materials.
Local regulations may provide for separate collection of electrical
products from the household, at municipal waste sites or by the
retailer when you purchase a new product.
D WALT provides a facility for the collection and recycling of
e
D WALT products once they have reached the end of their working
e
life. To take advantage of this service please return your product to
any authorized service center that will collect them on our behalf.
You can check the location of your nearest authorized service center
by contacting your local D WALT office. Alternatively, a service
e
center listing is included in the packaging of this product.

Troubleshooting

PROBLEM SOLUTION
Motor does not run Check power cord, plugs and outlet.
Ensure the on/off switch is in the ON
position ( ) and that the tool control
switch is in the off position.
PROBLEM
Suction capacity
decreases
WALT product needs
e
Vacuum stops running Thermal overload has been tripped:
Dust comes out while
vacuuming
Automatic filter
cleaning is not
working
Power tool does
not turn on the dust
extractor.
34
SOLUTION
Remove blockages in the suction nozzle,
suction tube, suction hose or filters.
Replace the paper or fleece bag.
Check for proper installation of the filters.
Clean or replace the filters.
Empty canister, refer to Empty Canister
under Operation.
1. Turn the vacuum off and disconnect
vacuum cleaner from power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an appropriate
outlet and turn on/off switch to the ON
position ( ) to test.
Check for proper installation of the filters.
Ensure filters are not damaged; replace if
necessary.
Ensure filter seals are in place and are
secure.
Listen for the solenoid clicking to ensure
the filter cleaning mechanism is working.
Ensure tool is plugged into the tool outlet
on the dust extractor.
Ensure the on/off switch is in the ON
position ( ).
Ensure the tool control switch is in the ON
position ( ).