Protecting The Environment - DeWalt DWV902L Traducido De Las Instrucciones Originales

storage unit, 1 storage unit per dust
extractor. Exceeding the recommended
height and/or weight could result in an
unstable dust extractor would could
cause injury or damage.
NOTICE: Do not remove dust extractor
head from tank with T-stack storage
units attached. Doing so could result in
damage to the dust extractor filters.
SECURING THE POWER CORD TO THE HOSE (FIG. 1)
The power cord (b) can be secured to the suction
hose (g) using the D279058CL hose clip (available
from your local D WALT supplier).
E
Consult your dealer for further information on the
appropriate accessories.
Troubleshooting
PROBLEM SOLUTION
Motor Check power cord, plugs and outlet.
does not
Ensure the on/off /tool control switch
run
is in the ON position ( ).
Suction Remove blockages in the suction
capacity nozzle, suction tube, suction hose
decreases or filters.
Replace the paper or fleece bag.
Check for proper installation of the
filters.
Clean or replace the filters.
Empty canister, refer to Empty
Canister under Operation.
Vacuum Thermal overload has been tripped:
stops
1. Turn the vacuum off and
running
disconnect vacuum cleaner from
power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/
off/tool control switch to the ON
position ( ) to test. If vacuum will
not restart contact your seller or
check the location of your nearest
authorised D
in the D WALT catalogue or
E
contact your D
address indicated in this manual.
PROBLEM
Dust
comes
out while
vacuuming
Automatic
filter
cleaning
is not
working
Power tool
does not
turn on.

Protecting the Environment

Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
D WALT office at the address indicated in this
E
manual. Alternatively, a list of authorised D
WALT repair agent
E
repair agents and full details of our after-sales
service and contacts are available on the Internet at:
WALT office at the
E
www.2helpU.com.
SOLUTION
Check for proper installation of the
filters.
Ensure filters are not damaged;
replace if necessary.
Ensure filter seals are in place and are
secure.
Listen for the solenoid clicking to
ensure the filter cleaning mechanism
is working.
Ensure the on/off/tool control switch is
in the ACTIVATION position
Separate collection. This product must
not be disposed of with normal
household waste.
WALT product
E
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
WALT products once they have
E
ENGLISH
.
WALT
E
33