DeWalt DW715 Manual De Instrucciones página 6

orthicker plywood which can then beclamped toyour w ork support ormoved toother job
sites and reclamped.
NOTE" Ifyouelect t omount your s aw toa piece o fplywood, make sure that t hemounting
screws don't p rotrude from thebottom ofthe wood. The plywood must sitflush onthe work
support. When clamping the sawtoany work surface, clamp only ontheclamping bosses
where t he mounting screw holes a relocated. Clamping atany other p oint will s urely i nterfere
with theproper operation ofthesaw.
_,OAUTION:
Toprevent binding and inaccuracy, be sure the mounting surface is not warped
or otherwise uneven. If the saw rocks on the surface place a thin piece of material under one
saw foot until the saw sits firmly on the mounting surface.
IMPORTANT SAFETY INSTRUCTIONS
Changing or Installing a New Saw Blade (Fig. 3)
_WARNING: To reduce the risk of serious personal injury, turn off the tool and
disconnect it from the power source before attempting to move it, change
accessories or make any adjustments.
_CAUTION:
• Never depress the spindle lock button while the blade is under power or coasting.
• Do not cut ferrous metal (containing iron or steel) or masonry or fiber cement product
with this miter saw.
Removing the Blade (Fig. 3, 3A)
1. Unplug the saw.
2. Raise the arm to the upper position and raise the lower guard (A) as far as possible.
FIG. 2
CARRY
HANDLE
TRIGGER
SWITCH
OPERATING
HANDLE
MOTOR
END CAP
CARRY
HANDLE
LOCK
DOWN
LEFT SIDE PIN
FENCE _
FENCE
LOCK
KNOB
BLADE
BENCH
MOUNTING
HOLES
HAND
INDENTATIONS
MOTOR
HOUSING
GUARD
jj BEVEL SCALE
MITER
SCALE
KERF
PLATE
BENCH
MOUNTING
HOLES
MITER
LOCK LEVER
MITER
LATCH
DUST SPOUT
45 ° BEVEL STOP
ADJUSTMENT
SCREW
BEVEL LOCK
KNOB
0°_5°BEVEL
OVERRIDE
LEVERS
BEVEL STOP
A 33,85 ° PAWL
LOCK DOWN
PIN
LEFT SIDE
FENCE
HAND
INDENTATIONS
FENCE LOCK
KNOB
O° BLADE
BEVELSTOP WRENCH
ADJUSTMENT
SCREW