Connecting To A Vcr, 15K Rgb/Component Equipment, Or A Monitor - Sony VPL-PX11 Manual De Instrucciones

Connecting to a VCR, 15k RGB/
Component Equipment, or a
Monitor
This section describes how to connect the projector to
a VCR, to 15k RGB/component equipment, or to a
monitor.
For more information, refer to the instruction manuals
of the equipment you are connecting.
To connect a VCR
Left side
MONITOR RS-232C
AUDIO
OUTPUT REMOTE
INPUT B
AUDIO RGB USB AUDIO
Stereo
audio
connecting
cable (not
supplied)
to audio
output
AUDIO
S VIDEO
VIDEO IN
VIDEO
~
AC IN
INPUT A
RGB
Video S-Video
cable (not cable (not
supplied) supplied)
to video
to S video
output
output
VCR
To connect 15k RGB/Component
equipment
Left side
AUDIO MONITOR RS-232C
OUTPUT REMOTE
INPUT B
AUDIO RGB USB AUDIO
Stereo
audio
connecting
cable (not
supplied)
to audio
output
15k RGB/Component
equipment
Notes
• Connect 15k RGB/component equipment to the
INPUT A connectors. You cannot connect this type
of equipment to the INPUT B connectors.
• Set the aspect ratio using ASPECT in the INPUT
SETTING menu according to the input signal.
For details, see page 25 (GB).
• When you connect the projector to 15k RGB/
component video equipment, select RGB,
component or VCR GBR as the INPUT-A setting in
the SET SETTING menu.
• Use the composite sync signal when you input the
external sync signal from 15k RGB/component
equipment.
Connecting the Projector
AUDIO
S VIDEO
VIDEO IN
VIDEO
~
AC IN
INPUT A
RGB
SMF-402 Signal Cable
(not supplied) HD D-sub
15-pin (male) y 3 ×
phono jack
to RGB/
component
output
17
(GB)