Notes For Installation; Unsuitable Installation; Unsuitable Conditions For Use - Sony VPL-PX11 Manual De Instrucciones

Notes for Installation

Notes for Installation

Unsuitable Installation

Do not install the projector in the following situations.
These installations may cause malfunction or damage
to the projector.
Poorly ventilated
• Allow adequate air circulation to prevent internal
heat build-up. Do not place the unit on surfaces
(rugs, blankets, etc.) or near materials (curtains,
draperies) that may block the ventilation holes.
When internal heat builds up due to blockage of the
ventilation holes, the temperature sensor may
function, a warning message will be displayed, and
the power may be turned off automatically after one
minute.
• Leave space of more than 50 cm (19
around the unit.
• Be careful that the ventilation holes do not inhale
tiny objects such as pieces of paper.
Highly heated and humid
• Avoid installing the unit in a location where the
temperature or humidity is very high, or the
temperature is very low.
• To avoid moisture condensation, do not install the
unit in a location where the temperature may rise
rapidly.
30
(GB)
Very dusty
Avoid installing the unit in a location where there is a
lot of dust; otherwise, the air filter will clog. The dust
blocking the air through the filter may cause the
internal heat level of the projector to rise. Clean the
filter periodically.

Unsuitable Conditions for Use

Do not do any of the following.
Toppling the unit
Avoid standing the unit on its side as the unit may
topple over. This may cause a malfunction.
3
/ inches)
4
Tilting the unit more than 15 degrees
Avoid tilting the unit at an angle of more than 15
degrees. Installation of the unit in this manner may
cause a malfunction.