Setting Into Operation; Automatic Mode; Music Control - IMG STAGELINE COMBI LIGHT Manual De Instrucciones

4 Mounting
GB
G
Always place the unit so that a sufficient air cir-
culation is ensured during operation. The air
vents at the housing must not be covered in any
case (e. g. by curtains).
G
The distance to the radiated object should be
50 cm as a minimum.
Fix the light effect unit via its mounting bracket (1)
to a suitable place, e. g. with a stable mounting
screw or a support for lighting units (C hook) to a
cross bar. To align the unit, release the two locking
screws (2) at the bracket, adjust the desired incli-
nation and retighten the screws.
WARNING The light effect unit must be mounted
in a safe and expert way. If it is in -
stalled at a place where people may
walk or sit under, it must additionally
be secured [e. g. by a safety rope;
lead the safety rope through the
safety lug (8) and fix it so that the
maximum falling distance of the unit
would not exceed 20 cm].

5 Setting into Operation

WARNING Never look directly into the light
source, this may cause eye damage.
Please note that stroboscope effects
and fast changes in lighting may
trigger epileptic seizures with photo -
sensitive persons or persons with
epilepsy!
1) To switch on, connect the mains cable supplied
to the mains jack (4) and the plug to a socket
(230 V~/ 50 Hz). The display shows the last
adjustment for 10 seconds.
2) To switch off the unit, disconnect the mains
plug from the socket.
For a more convenient operation, it is recom-
mended to connect the unit to a socket which can
be switched on and off via a light switch.
Caution: Do not connect the unit to the mains volt-
age via a dimmer!
5.1 Operation
The adjustments of the unit are made via a system
menu which can be operated by means of the but-
tons (10) and the display (9). The 4-digit display is
activated by pressing any button and shows the last
adjustment. The indication will be extinguished a
few seconds after the last button has been pressed.
10
The buttons have the following functions:
– button ESC/MENU to return to the previous
menu level
– button ENTER to go to the next menu function
– buttons UP and DOWN to select between several
menu options
The menu structure is shown on page 13.
6 Operation without Controller

6.1 Automatic mode

For an automatic light show three programmes are
available:
1) Press the button ESC/MENU so many times
until the main menu is reached.
2) Select the option
button UP or DOWN.
3) Press the button ENTER: The last programme
adjusted (
,
displayed. Select the desired programme from
the three programmes with the button UP or
DOWN.
4) To change the speed, press the button ENTER:
The present speed is displayed. Select the
desired speed from the 9 speeds
with the button UP or DOWN.

6.2 Music control

For music-controlled run of the light show three
music modes, Sound 1 to Sound 3, are available:
music-controlled stroboscope
via the LED bar
music-controlled stroboscope
via the LED rosettes
music-controlled activation of programmes
1) Press the button ESC/MENU so many times
until the main menu is reached.
2) Select the option
button UP or DOWN.
3) Press the button ENTER: The last music mode
adjusted is activated and displayed. Select the
desired mode from the three modes with the but-
ton UP or DOWN.
4) To change the speed for Sound 3, press the but-
ton ENTER: The present speed is shown. Select
the desired speed from the 9 speeds
with the button UP or DOWN.
Note: A change of speed has no effect on Sound 1 and
Sound 2.
in the main menu with the
or ) is activated and
to
in the main menu with the
to