Opening The Gator® Speedload™ (Gsl); Closing The Gsl Head - Oregon ST275-GSL Manual De Instrucciones

OPENING THE GATOR®
SPEEDLOAD™ (GSL)
WARNING: A BATTERY OPERATED
TOOL WITH THE BATTERY PACK
INSERTED IS ALWAYS ON AND CAN
START ACCIDENTALLY. REMOVE THE
BATTERY PACK FROM THE TRIMMER/
EDGER BEFORE INSPECTING,
CLEANING, OR PERFORMING
MAINTENANCE.
If you detect a problem with the operation of
the GSL Cutting System and need to inspect
the disk or head, follow these steps to open
the GSL head:
• Remove the battery, then place the trimmer/
edger upside down
• Press the GSL head to release the bottom
part of the base (Fig 17)
FIG 17
Oregon® Trimmer/Edger Model ST275-GSL
ST275_Operating_Manual_EU.indd 25
SAFETY RULES

CLOSING THE GSL HEAD

• Check the disk and clear any blockage or
replace the disk See "Replacing the Gator®
SpeedLoad™ (GSL)"
• Remove clippings, dirt, and debris
• Place GSL head back onto the base and
press firmly until it clicks into place
(Fig 18)
FIG 18
25
17/06/16 9:44 AM