Removing And Replacing The Gator® Speedload™ (Gsl) Head - Oregon ST275-GSL Manual De Instrucciones

REMOVING AND REPLACING THE
GATOR® SPEEDLOAD™ (GSL)
HEAD
If the GSL head is cracked or broken, it should
be removed and replaced If there is a build-up
of clippings or debris between the head and
the guard, it is easier to clean the trimmer/
edger if the head is removed first
• Remove the battery, then place the trimmer/
edger upside down
• Follow the instructions in "Opening The GSL
Head "
• Use a straight-blade screwdriver to restrain
the spindle and rotate the trimmer base
counter-clockwise to loosen the centre nut
(Fig 23)
FIG 23
• Pull out the GSL base
• Remove the grass wrap protector from the
trimmer head (Fig 24)
FIG 24
Oregon® Trimmer/Edger Model ST275-GSL
ST275_Operating_Manual_EU.indd 27
SAFETY RULES
• Insert the new grass wrap protector
• To attach a new GSL head, slide the nut into
the centre opening of the GSL head (Fig 25)
FIG 25
• Place the GSL head inside the trimmer
housing
• Tighten the nut securely (Fig 26)
FIG 26
• Follow the instructions in "Loading a new
GSL disk" to place a new disk of trimmer line
into the trimmer/edger
• Close the head
27
17/06/16 9:44 AM