Audio Adjust - Pioneer HTP-076 Manual De Instrucciones

3. Audio Adjust

„ 1. Dual Mono / Mono
Change the settings of multiplex audio playback.
Setting Item Default Value
Dual Mono Main
Mono Input Left + Right
Channel
„ 2. Dolby
Change the setting of when Dolby signals are input.
Setting Item Default Value
Loudness On
Management
Setting Details
Set the audio channel or language to be output
when playing multiplex audio or multilingual
broadcasts, etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels are output at
the same time.
• For multiplex audio broadcasts, pressing the
button on the remote controller will display "1+1"
on the main unit's display.
Set the input channel to play 2-ch digital sources
such as Dolby Digital, or 2-ch analog/PCM sources
in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels
Setting Details
When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Midnight function that allows you to enjoy
surround at low volumes is fixed to off when playing
Dolby Digital Plus/Dolby TrueHD.
"On": When this function is used
"Off": When this function is not used
Contents Connections
≫
„ 3. DTS
Change the setting of when DTS signals are input.
Setting Item Default Value
Dialog Control 0 dB
„ 4. Volume
Change the Volume settings.
Setting Item Default Value
Mute Level -∞ dB
Volume Limit Off
Power On Volume Last
Headphone Level 0.0 dB
76
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
You can increase the volume of dialog portion of
the audio up to 6 dB by 1 dB step so that you can
hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not
be selected.
Setting Details
Set the volume lowered from the listening volume
when muting is on. Select a value from "-∞ dB",
"-40 dB" and "-20 dB".
Set the maximum value to prevent the volume
from becoming too loud. Select a value from "Off",
"-32 dB" to "+17 dB".
Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "-∞ dB", and "-81.5 dB" to
"+18.0 dB".
• You cannot set a higher value than that of
"Volume Limit".
Adjust the output level of headphones. Select a
value between "-12.0 dB" and "+12.0 dB".
≫