Miscellaneous; Firmware Update; Initial Setup - Pioneer HTP-076 Manual De Instrucciones

Setting Item Default Value Setting Details
USB Power Out Off When this function is set to "On", electricity can be
at Standby supplied to the Streaming media player connected
to the POWER OUT port even if this unit is in
standby mode.
• The POWER OUT jack is cannot supply power to
• While using this function, power consumption
Contents
smart phones/tablets or other devices.
increases in standby mode, however, the
increase in power consumption is minimized by
automatically entering the HYBRID STANDBY
mode where only the essential circuits are
operating.
Connections
≫

6. Miscellaneous

„ 1. Tuner
Change the frequency step for the tuner.
Setting Item Default Value
AM/FM 10 kHz/0.2 MHz Select a frequency step to suit your residential
Frequency Step
(North American
models)
AM Frequency 9 kHz
Step (European,
Australian and
Asian models)
„ 2. Firmware Update
Change the settings for Firmware Update.
Setting Item Default Value
Version -
Update via USB -
„ 3. Initial Setup
Make the initial setup from the setup menu.
„ 4. Lock
Lock the Setup menu so that the settings cannot be changed.
Setting Item Default Value
Setup Parameter Unlocked
82
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
area.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets
are deleted.
Select a frequency step to suit your residential
area.
Select "10 kHz" or "9 kHz".
• When this setting is changed, all radio presets
are deleted.
Setting Details
The current firmware version is displayed.
Press ENTER to select when updating the firmware
via USB.
Setting Details
Lock the Setup menu so that the settings cannot be
changed.
"Locked": The menu is locked.
"Unlocked": The menu is unlocked.
≫